Config.
2 way mono-amplified
Configuration
LRx 2.4 and LRx 2.9
For setting the control panel switches properly, refer to
the diagrams in the Filter section, starting on page 53.
Filters configuration
Input/Output configuration
You can independently select a bypass, hi-pass or
lo-pass filter to be applied to the amplifier and to PRE
OUT output. If the amplifier and the PRE OUT output are
configured in the same way, both will output the same
signal and cut-off frequency selected.
In stereo mode: When INPUT is stereo, and HI-PASS
and/or LO-PASS filter is set to12 dB, a stereo filtered
signal will be directed to the PRE OUT outputs and to
the amplified outputs. When the filter is set to LO-PASS
24 dB, a lo-pass mono filtered signal is directed to the
PRE OUT outputs and to the amplified outputs, the sum
of the L + R signal inputs.
In mono mode, only the right input is activated.
You will have a mono signal in PRE OUT and in amplified
outputs with whatever types of selected filter. Only the
right BYPASS output connector will have the same signal
as the right channel input.
2 way + Sub tri-mode
Comments to this Manuals