Audison LRX2 500 Owner's Manual download pdf (Page 8)

CONTROLS PANEL

LIMIT (orange LED)

It indicates the Overload Limiter circuit is on.

Caution:

When this led is on (although sporadically), it means the applied load is a hard one.The activation

of Overload Limiter circuit (output power limiter) will anyway allow the amplifier to function

without distortions. In case Overload Limiter gets on too frequently (at every power peak), you will

need to check if there are any failures or a too hard load (that’s to say impedance is about 50%

lower than the minimum recommended one). The amplifier can go on functioning in these

conditions but power will inevitably decrease.

HI-PASS

It permits to choose whether to send a full range signal (BYPASS) or a 12dB/Oct. HI-PASS signal for

high frequencies (ON) to the preamplified output (PRE OUT).

ON (green LED)

It indicates the

amplifier is on.

FUNCTIONS AND CONTR

OLS

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

No comments

Audison LRX2 500 Owner's Manual Page 8