Audison LR 435 Owner's Manual download pdf (Page 9)

9

CONTROLS PANEL

LO-PASS

It permits to activate (On) or bypass

(Bypass) the LO-PASS filter. In this way,

a Lo-Pass signal or a full range one will

be on the output, that is selected by

AMP: HI/LO-PASS switch.

9

HI-PASS

It permits to activate (On) or bypass

(Bypass) the HI-PASS filter. In this way,

a Hi-Pass signal or a full range one will

be on the output, that is selected by

AMP: HI/LO-PASS switch.

8

MODE

It permits to switch the amplifier

functioning mode between Stereo and

Mono (bridged).

4

F1

It permits to set Lo-Pass and Hi-Pass

crossover point between 40 and 500 Hz.

6

LEVELS

It adjusts the input sensitivity of both

amplifier channels and sets their output

level.

5

SAFETY (red LED)

It indicates that the amplifier protection

circuits are on. In order for the amplifier

to work again, you need to switch the

system off and then on after 10 seconds

at least. We recommend to check all

connections before switching the

amplifier on again.

If LED stays on, please contact Audison

authorised after sale centres.

10

RANGE: x1/x10

Frequencies range switch.

It permits to select the preset frequencies

ranges within which to realise the

crossover point between Lo-Pass and

Hi-Pass through F1.

x1 ➾ 40 ÷ 500Hz

x10

➾ 400Hz ÷ 5kHz

7

12

16

16

CONFIGURATION EXAMPLES

MONO (FRONT+SUB)

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments