Audison bit Ten D Installation Guide Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 50
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
ADVANCED MANUAL / bit Ten D /
7
1. POWER SUPPLY.
+BATT 12V: Positive connection terminal for car 12V power supply.
-BATT: Power supply negative connection terminal (GND).
WARNING: make sure the connection polarity is as indicated on the terminals. A misconnection
may result in damage to the bit Ten D. After applying power, wait at least 10 seconds
before turning the bit Ten D on.
2. REMOTE IN-OUT.
REM IN: input to turn on the processor remotely along with the audio signal Remote Out.
REM OUT: output to turn on other devices / amplifiers connected after the processor.
From the REMOTE-IN signal, the processor only takes 1 second to supply the signal to the REM OUT output.
The 130-mA output current capability can also drive an automotive relay (making sure it doesn’t exceed 130 mA).
WARNING: the bit Ten D must be switched on before any amplifiers are turned on.
The system sources Remote Out must be connected to the product REM IN, and the product REM OUT
is then to be connected to the Remote In of other devices / amplifiers.
4.3 OUTPUT SIGNALS
4.4 INPUTS – REMOTE CONTROL OUTPUTS AND POWER SUPPLY
4
1. FRONT L-R, REAR L-R, SUB OUTPUTS;
Low-level analog signal.
Connection for RCA cables going to
the system amplifiers.
SUB output is provided with CONSTANT BASS
(when varying the fader,
the SUB volume does not change). (see 5.7)..
2. AD Link;
S/PDIF standard digital signal output (Ch1÷Ch8) to
connect amplifiers provided with appropriate
AD Link input.
3. AC Link;
Connection bus to control the amplifiers provided with
AC Link connection.
1
1
2
3
4
1: violet
2: gray
3: white
4: green
5: red
6: pink
7: brown
9: blue
10: cyan (light blue)
11: violet
12: gray
13: white
14: green
15: red
16: pink
17: orange
18: yellow
20: black
5
3
2
6
POWER SUPPLY
REMOTE
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 49 50

Comments to this Manuals

No comments